Pearl Coating™ 20oz/600ml Sublimation Glitter Stainless Steel Silver Skinny Tumbler with Straw & Lid - Pack of 5

Press Temperature: 360˚F (165C) for 75 seconds | Medium Pressure, Hot peel

1. Remove the lid and straw. Make sure you are using the Tumbler Element.
2. Tape imaged sublimation paper onto your tumbler. Place the image facing the tumbler.
3. Set the mug press at 360˚F for 75 seconds. Adjust the time accordingly if your press has an idle and press temperature setting.
4. Ensure the mug press has reached temperature. Place the tumbler into your mug press. Close Mug Press.
5. Once pressing is done, open the mug press, and take the tumbler bottle out of the press.
   Use gloves or heat-resistant cloth to handle the hot tumbler.
6. Peel the sublimation paper off.
7. Leave on the table to cool. Do not dunk in water.

Caution:  Tumbler is extremely hot when in the mug press, do not handle it with bare hands
Note: Temperature and time settings are only a guide/starting point, some convection ovens may require some fine tweaking of the temperature and time.  

Press Temperature: 320°F |  Time: 6 minutes (test in your oven for accurate time) | Peel: Hot

1. Remove plastic lid and metal straw.
2. Print your design. Don't forget to mirror.
3. Secure your transfer to the tumbler using heat-resistant tape. The transfer should not extend past the edges of the tumbler.
4. Place the tumbler inside the shrink wrap centering it as best you can.
5. Use a heat gun on a low setting to shrink the wrap to the contour of the tumbler, it is best to start on the side away from the transfer first.
6. Repeat steps 2 through 4 for each item you wish to sublimate in the production run.
7. When the items are ready place them into a preheated convection oven.
8. Once the item is finished sublimating, remove the shrink wrap and sublimation paper. It may break into smaller pieces that just have to be pulled off the item.
9. Leave on the table to cool down.